1999 EE Johnson Outboards 25, 35 3-Cylinder Service Manual, Page 218Get this manual
Solenoid Tests
All engine wiring must be disconnected from the solenoid before proceeding with this test1Calibrate ohmmeter on appropriate scaleConnect one lead to terminal and the other lead to terminal Ohmmeter should show high reading If ohmmeter shows low reading, replace the solenoid
2With the ohmmeter still connected as described in Step 1, attach positive battery jumper to terminal and negative battery jumper to terminal The solenoid should close with an audible click Ohmmeter should show low reading If ohmmeter shows high reading, replace the solenoid
3After installing the solenoid, coat all wires and terminals with
CIVIC Black Neoprene Dip
No Load Current Draw, Electric Starter
Securely fasten starter in vise or other suitable fixture before proceeding with this check1Locate battery rated at 500 CCA (60 amp-hr) or higher that is in good condition and fully charged