1999 EE Johnson Outboards 25, 35 3-Cylinder Service Manual, Page 193Get this manual
Assembly
Make no dry assembliesLubricate bearings, shafts, and gears with OMC Ultra-HPF gearcase lube
1Oil and install new bearing in aft end of the bearing housing using OMC Bearing Installer, PIN 335820Press against the lettered side of the bearing to prevent damage to the bearing when installingPress the bearing into the housing until the tool is seated on the housing
rn 2Oil and install aOMC Bearing Installer,forward end of the new bearing in the bearing housing using PIN 321428Press
against the lettered side of the bearing until the tool is seated on the bearing housing
3Install new seals back to back in aft end ofthe bearing housing using OMC Seal Installer, PI 335821Apply OMC Gasket Sealing Compound to the metal casing of the seals before installingInstall the inner seal with lip facing into the bearing housing and install the outer seal with lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installing