1999 EE Johnson Outboards 25, 35 3-Cylinder Service Manual, Page 165Get this manual
Installation
[] 1Slide the protective sleeve over the stop button leadsInsert the stop button leads and the throttle cable through the lower engine cover grommet
2Apply OMC Triple-Guard grease to the two steering handle bushingsPlace the bushings into the steering bracketAttach the steering handle to the steering bracketTighten the screw so the steering handle can be pivoted and maintain any position
3Secure stop button ground lead to the ground stud Tighten the nut securelyApply CIVIC Black Neoprene Dip to the stud and nut4Using OMC Insert Tool, PIN 322697, install the stop button lead into the plugConnect the 1-pin Amphenol connector Secure connector in the bracket
5Secure wires to lower engine cover with J-clamp and screwTighten screw securely[[] 6Install the electrical connector cover and secure with two screws Tighten the screws securely[]] 7Thread the connector onto the cable housing 134 in(44 mm) from end of the cable sleeve[] 8Attach connector to bracket and secure with shoulder bolt and spacer Tighten bolt securely[] 9Pivot bracket cover and tighten retaining screw securely13f4in(44mm)-