1999 EE Johnson Outboards 25, 35 3-Cylinder Service Manual, Page 145Get this manual
m rn 55hoses CDonethe powerheadInstall crankcase oiling recirculating to
and three
56Install all carburetion, ignition, and electrical components on the powerhead following instructions found in their respective sectionsInstallationTiller Models
rn 1Coat bothCompound new powerhead baseexhaust with OMC sides of gasket Gasket Sealing and install it on the housingrn 2.lubricant to the end of the driveshaft as lubricant here may Coat the driveshaft splines Q) with OMC MolV LubeDo not apply
prevent seating of driveshaft in crankshaft
3Attach OMC Lifting Eye, PI 396748, to the flywheel and tighten the screws only enough to ensure thread engagement
INote Threading the lifting eye screws in too far into the flywheel