1999 EE Johnson Outboards 25, 35 3-Cylinder Service Manual, Page 127Get this manual
[] 7Tiller Electric Models: Remove the two screws securing the electrical connector cover to the engineRemove the cover 8Disconnect the stop switch wire connectorRemove the stop switch wire from the ground stud 9Tiller Electric Models: Disconnect the 6-pin connector
rn 10.wires (yellowred) from Remove the twoMake surestart Tiller Electric Models: neutral switch the connectorto
identify the pin locations (2 and 6) for installation during reassembly
11Remove the throttle cable ball socket from the ball on the throttle lever using OIVIC Ball Socket Remover, PI 342226Remove the clip securing shift rod CD to shift leverRemove shift rod from lever12Remove the two screws Q) securing the trunnion anchor block to the engine