1999 "EE" Evinrude 70HP 4-Stroke Service Manual, P/N 787023, Page 204Get this manual

1999 "EE" Evinrude 70HP 4-Stroke Service Manual, P/N 787023, Page 204

DRC6247
Trim Sender Troubleshooting

INote To avoid immediate meter damage, never apply an ohm meter to an electrical circuit where voltage is present1Disconnect the 3-pin Deutsch connector between the instrument harness and engine trim harness

2Calibrate an ohmmeter on the appropriate scaleConnect the meter between the whitetan wire, terminal "C", ofthe engine harness and clean engine groundWith the engine fully DOWN, meter must show reading above 80 ohmsWith the engine fully UP, meter must show reading below 10 ohms If your results agree, refer to Trim Gauge Troubleshooting If your results are different, replace trim sender

Back to 1999 "EE" Evinrude 70HP 4-Stroke Service Manual, P/N 787023