1999 "EE" Evinrude 5 thru 15 4-Stroke Service Manual, P/N 787022, Page 279Get this manual
9Hold rope taut and release starter lockoutAllow rope to slowly wind into starter10Remove nut and pulley retainer from mandrel and remove starter assembly
11Install spindle screw and tighten to 120-144 inIbs(14-16 Nm)Install retaining ring 12Install pawl, linkage, and retaining ring (sharp edge up)
13Check operation of the pawlThe pawl should extend when the starter rope is pulled and retract when the rope rewindsInstallation
1Position starter on motorInstall starter screws and tighten to 60-84 inIbs(7-9 Nm)2Snap fuse connection into starter cover3Attach clevis end of starter lockout link to bellcrank