1999 "EE" Evinrude 5 thru 15 4-Stroke Service Manual, P/N 787022, Page 252Get this manual
Assembly
Make no dry assembliesLubricate bearings, shafts, and gear with OMC Ultra-HPF gearcase lube
1Oil the small bearing and install it in the propeller shaft bearing housing using OMC Bearing Installer, PIN 339751Press against the lettered side of the bearing when installing
2Oil the large bearing and install it in the propeller shaft bearing housing using OMC Bearing Installer, PI 339751Press against the lettered side of the bearing when installing32560
rn 3.rear of the Seal Installer, PI Apply DPL Penetrating LubriUse OMC 342663, to install new seal in the bearing housingcant to the casing of the seal before installingInstall the seal with the exposed lip facing away from the bearing housingPress the seal into the housing until the tool seatsApply OMC Triple-Guard grease to the seal lips after installing4Apply OMC Triple-Guard grease to new bearing housing a-ringPlace the a-ring in the bearing housing groove