1999 "EE" Evinrude 5 thru 15 4-Stroke Service Manual, P/N 787022, Page 178Get this manual
9Lubricate the cylinder walls with oilLubricate the inside surface of an expandable piston ring compressor and place the piston and rod assembly inside INotel
Be sure the piston rings are at the prescribed angles per Step 8
[] 10Place the ring compressor with piston and rod on the cylinder block, and align with cylinder boreThe stamped arrow on the piston crown and the "F" on the rod faces the flywheel endTap piston into bore with wood hammer handle end or equivalent
11 If removed, install new crankshaft sleeve with O-ring on end of crankshaft using avIC Crankshaft Sleeve Installer, PIN 342662, until seated Apply avIC Moly Lube to the O-ring 12Lubricate new bearing halves with oil and install in cylinder block with bearing edge flush with block