1999 "EE" Evinrude 5 thru 15 4-Stroke Service Manual, P/N 787022, Page 168Get this manual
10Push bearings out of cylinder block and retain for inspection
[] 11Remove and replace dowel pins from cylinder block, if necessary
12Remove crankshaft seals and discard them 13Remove O-ring from crankshaft and discard it
14Inspect the crankshaft sleeve and replace, if necessaryTo remove, use OMC Slide Hammer, PI 432128, and OMC Small Jaw Puller, PIN 43213115Remove pistons from cylinder block by gently pushing on rod, forcing pistons outDo not allow rod to contact cylinder wall16Mark pistons for location prior to removal from rods