1999 "EE" Evinrude 5 thru 15 4-Stroke Service Manual, P/N 787022, Page 138Get this manual
[] 8Inspect valves for contamination, excessive wear, or damagePay particular attention to the valve seat face, replace if pittedValve stems that show excessive wear or are warped should be replaced[] 9Use micrometer to measure the camshaft lobesRefer to Engine Specifications, Section 1, for dimensions
10Inspect rocker arms for contamination, excessive wear, or damage
W Important Some wear to the face of the rocker arm is
normalReplace if wear is severe enough to show porosity (pitting) on the face
11Use micrometer to measure the diameter of each crankpin and main bearing journalRefer to Engine Specifications, Section 1, for dimensions
12Use OIVIC Cylinder Bore Gauge, PI 771310, to inspect each cylinder bore for an out-of-round, oversize, or tapered conditionBe sure the gauge or micrometer is perfectly square in the bore when measuring13Measure each cylinder in at least two areasMeasure each area twiceThe difference between the two measurements in each area is the cylinder out-of-round dimensionThe cylinder must not be out of round by more than 0.003 in(0,08 mm)