1999 "EE" Evinrude 5 thru 15 4-Stroke Service Manual, P/N 787022, Page 94Get this manual
4Push connector halves together and secure with retainerBundle wires and connector and secure with tie strap
[] 5Place stator in positionApply OMC Ultra Lock to screws and install; do not torque at this timeRoute wire sleeve through clamp, apply OMC Nut Lock to clamp screw, position, and torque to 36-60 inIbs(4-6 Nm)6Use OMC Stator Alignment Guide Kit, PI 342670, and OMC Locating Ring, PIN 334994 to properly position stator
7Install guide bridge on OMC Locating Ring, PI 334994, and secure with set screws
8Install appropriate end of guide bushing taper aligned with key
crankshaft
9Place bridge and ring assembly over bushing and move stator until it contacts locating ring10Torque stator screws to 36-60 inIbs (4-6 Nm)[] 11Install flywheel and place flywheel sensor in positionAttach whiteblack wire to sleeve with tie strap