1999 "EE" Evinrude 5 thru 15 4-Stroke Service Manual, P/N 787022, Page 75Get this manual
12Install the carburetor body cover and gasketTighten the screws to torque of 8-10 inIbs(0,8-1,2 Nm), following sequence embossed on cover13Install the idle mixture needle and springTurn needle carefully until it lightly contacts the seat; then back it off:15 TurnsTurns 14Apply RTV silicone rubber adhesive sealant to screw after adjustmentInstallation9.915 (305cc)
1Position new gasket on either side of the insulator and install on the intake manifold
ern 2Install the carburetorTighten two retaining nuts securelyI::1ID
3 Install the choke cable in link and attach to powerhead with clampTorque to 60-84 inIbs(7-9 Nm)Attach hoses to carburetor nipples and secure with tie straps
4Install the air horn cover and tighten screws securelyInstall air horn and carburetor nipple hoses with tie straps