1999 "EE" Evinrude 5 thru 15 4-Stroke Service Manual, P/N 787022, Page 74Get this manual
Assembly56
INote Before proceeding, be sure that all parts are cleanBe sure
that all replacement parts match original onesReplace all gaskets, O-rings, and sealing washers each time you assemble carburetor
1Install accelerator rod plungerdiaphragmand spring with cover onto float chamberInstall screw to retain in place
2Press the air vent in the carburetor body
3Install the high-speed orifice Install the gasket Q) and valve seat
5Install the hinge pinfloatand float valve
6Check for correct positioning of the float levelThe float level controls the height of fuel in the float chamber and is critical with regard to carburetor calibration and function
Turn carburetor upside down and hold so gasket surface is horizontalThe weight of the float will close the float valve needleRest OMC Float Gauge, PIN 324891on gasket surface and slide gauge up, next to floatTop of float should be between notches on gauge
Use notch that is indicated9.915 HP Be certain gauge is not holding down the float If float level is not between the notches of gauge, lightly bend metal float arm to adjust levelBe careful not to force float needle valve into seat