1999 "EE" Evinrude 200, 225 V6 FFI Outboards Service Manual, P/N 787025, Page 223Get this manual
Installation
1Coat the driveshaft splines with OMC Moly LubeDo not coat top surface of the driveshaft as lubricant here may prevent seating of the driveshaft in the crankshaft
2Apply OMC Adhesive sealant to the lower exhaust housing seal inner surfacesPosition two new seals on the housingApply OMC Triple-Guard grease to the seal's outer surfaces, and position the housing on the gearcase
3Rotate the propeller shaft and shift the gearcase to FORWARD4On relieved split-line exhaust housings, apply OMC Gel-Seal" to gearcase mating surface padsSlide the gearcase into place, making sure the driveshaft engages the crankshaft, the water tube enters the water pump, and the lower inner exhaust housing does not slip out of position