1999 "EE" Evinrude 200, 225 V6 FFI Outboards Service Manual, P/N 787025, Page 214Get this manual
7 DR2061DR2062
7Install two new seals back to back in rear of the bearing housing, using OIVIC Seal Installer, PIN 336311Apply OMC Gasket Sealing Compound to the metal casings of the seals before installingInstall the inner seal with lip facing toward the bearing housing, then the outer seal with lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installing
[] 8Lightly apply OIVIC Triple-Guard grease to new bearing housing a-ringsInstall a-rings in its grooves in the housing Driveshaft Bearing Housing Service
The driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damaged Also, inspect the driveshaft bearing surface if the bearing is damaged[] 1Remove the seals using OMC Puller Bridge, PI 432127, and OMC Large Puller Jaws, PI 432129Discard the seals2Remove the a-ring from the bearing housing and discard it3Clean the bearing housing in solvent to remove sealer from the seal bore and the a-ring groove4Install new seals back to back in bearing housing using OMC Seal Installer, PIN 330268Apply OMC Gasket Sealing Compoundto metal casings of the seals before installingInstall inner seal with flush lip facing toward bearing housing, then the outer seal with extended lip facing away from bearing housing Apply OMC Triple-Guard grease to seal lips14156