1999 "EE" Evinrude 200, 225 V6 FFI Outboards Service Manual, P/N 787025, Page 213Get this manual
Propeller Shaft Bearing Housing Service
1Remove the seals using OVIC Puller Bridge, PI 432127, and OVIC Small Puller Jaws, PI 432131Position the plate on top of the housing to support the bridge, and tighten the jaws securely behind the inner sealplaceIf bearing is removed for any reason, it must be discarded
INote Inspect bearings in
2Remove either bearing using OVIC Puller Bridge, PIN 432127, and OVIC Large Puller Jaws, PIN 432129Rest the puller plate on top of the housing to support the bridge, and tighten the jaws securely behind the bearing
[] 3Discard the bearing housing O-ringsClean the housing and bearings in solvent, and dry thoroughlyIf bearings were not replaced, rotate the needles with your fingers to check for freedom of movement