1999 "EE" Evinrude 200, 225 V6 FFI Outboards Service Manual, P/N 787025, Page 163Get this manual
19Using an appropriate bearing separator, support the lower bearing and press it off the crankshaft
INote If the lower main bearing is removed from the crankshaft,
it must be discardedDo not reuse itW
20To remove the upper crankshaft seal, use drift punch as shownRemove and discard crankcase head O-rings21Remove crankcase seal rings for inspectionIdentify each ring for installation in original location
22Remove center main bearings and split sleeves for inspectionDo not mix parts23Using an appropriate ring expander, remove all piston rings from pistonsDiscard the rings
[] 24Using tool as drawn on Page 9-6, or OMC Retaining Ring Pliers, PIN 325937, remove all wrist pin retaining ringsDiscard retaining rings]25Support pistons in OMC Piston Cradle, PI 326572, and remove wrist pins with OMC Driver, PI 396747]26Be careful notto lose any ofthe 33 needle bearings or the two wrist pin washersIf ANY of the bearings are worn or lost, replace ALL 33 needle bearings during reassembly49423