1999 "EE" Evinrude 200, 225 V6 FFI Outboards Service Manual, P/N 787025, Page 154Get this manual
Engine Temperature Check The Markal Thermomelt Stik, is heat-sensitive marker that melts on contact with surface of specific temperatureOne source for Thermomelt Stiks is Stevens Instrument Company
least two Thermomelt Stiks or OMC Temperature Gun, PI 772018, or digital pyrometer should be used to accurately determine the engine's operating temperatures
The Thermomelt Stik mark will appear dull and chalky when the surface marked is below the Stik's rated temperatureWhen the surface exceeds the Stik's rated temperature, the mark will appear liquid and glossyDR6825
To achieve accurate and consistent readings, engine temperature must be gauged at the top of each thermostat pocket
To troubleshoot and isolate cooling system problem properly, be sure to test both cylinder heads
INote For the following engine operating temperatures and RPM
figures to be correct, the inlet water temperature must be 70 10 (21 C)
Pyrometer Procedure
INote If you