1999 "EE" Evinrude 200, 225 V6 FFI Outboards Service Manual, P/N 787025, Page 128Get this manual
Starter Solenoid Test
INote All engine wiring must be disconnected from the solenoid
before proceeding with this test[] 1Calibrate ohmmeter on appropriate scaleConnect one lead to terminal and the other lead to terminal Ohmmeter should show high reading If ohmmeter shows low reading, replace the solenoid[] 2With the ohmmeter still connected as described in Step 1, attach positive battery jumper to terminal The solenoid should close with an audible click Ohmmeter should show low reading If ohmmeter shows high reading, replace the solenoid[] 3Move ohmmeter lead from terminal to terminal and repeat Step 2Results should be the same4After installing the solenoid, coat all wires and terminals with OIVIC Black Neoprene Dip
No Load Current Draw, Electric Starter