1999 "EE" Evinrude 200, 225 V6 FFI Outboards Service Manual, P/N 787025, Page 89Get this manual
IT] C Check for switched B+ at purple wire
of relay socket
No voltagerepair purple wire or replace engine harness
Slightly less than battery voltageverify B+ from starter solenoid at red wire of relay socket- OK, replace relayNo voltage, repair red wire or replace engine harness
Action StepsOil System
INote For reference, see oil flow diagram in Section 8IfLOW OIL" gauge light is on, fill oil tankIf "NO OIL" light is on, or lubrication problems are suspected, continue below :
Step 1: Static Verification
A Remove starter and fuel filter assembly BVerify all oil distribution hoses are purged of air(Crank or run engine while restricting oil return line until oil is present at all oil injector nozzles CRemove all oil distribution hoses while pumping oil primer bulbEOil injector should click as small amount of oil is discharged from each injector hose Oil injector doesn't clickgo to Step No output on all, but oil injector clicksgo to Step No output on somenote problem hosesGo to Step