1999 "EE" Evinrude 200, 225 V6 FFI Outboards Service Manual, P/N 787025, Page 73Get this manual
Step 4: If engine won't crank, check the following: Main battery switch (if present) Battery and connections Position fusego to Diagnostic Guide prevent injury, all spark plug leads nected to spark tester adjusted to 716 incranking testsDo not attach spark tester bracketsBe sure spark tester is held at least from all wires and sensor leads & To
must remain con(11 mm) during all to the ECU or its in(51 mm) away
Step 5: If engine will crank but not start, perform cranking spark test with tester adjusted to 716 in(11 mm)
INote Engine will
Results:
crank over as long as Position fuse is okay regardless of condition of remaining six fuses in power distribution panel and start assist circuit fuse Steady spark on allfault is in fuel or electrical systemGo to Step No spark on some or allnote problem cylindersGo to appropriate symptom in Diagnostic Guide
Step 6: If engine will run, perform the following tests (while problem is occurring, if possible)
INote OMC Diagnostic Software is able to perform cylinder drop