1999 "EE" Evinrude 200, 225 V6 FFI Outboards Service Manual, P/N 787025, Page 42Get this manual
Throttle Plate Synchronization
INote Apply
light pressure to throttle plates during this procedure to make sure they close completely1Remove the air silencer
ITJ 2Loosen, but do not remove, the port throttle lever screw
and the starboard throttle lever screw Do not remove links
Loosen but do not remove, the bottom screw on the port throttle shaft connectorLoosen, but do not remove, the top screw on the starboard throttle shaft connectorSeat all throttle platesTighten throttle shaft connector screwsin reverse order
ITJ 4ITJ 5ITJ
Verify that throttle levers around their throttle shaft
and can rotate freely
6Seat all throttle platesAdjust idle stop Q) until cam follower roller just touches the throttle cam at bisect point CDstarboard throttle plates are closed
ITJ 7Tighten starboard throttle lever screw making sure the