1999 "EE" 90, 115 FFI, 150, 175 V4, V6 FFI Outboards Service Manual, P/N 787024, Page 246Get this manual
COA3168
COA3130
, and shim(s)
25Position the driveshaft thrust bearingthrust washer (selected earlier) on the driveshaft
120 II Note Position bearingwasherand shim(s) exactly
in the order shown26Apply light coat of OIVIC Gasket Sealing Compound to the gearcase area that contacts mounting flange of the bearing housingDo not coat inside bearing housing bore surface of the gearcase
27Using OIVIC Driveshaft Seal Protector, PIN 318674, slide the driveshaft bearing housing onto the driveshaft28Push down on the shift rod to engage REVERSE gearTurn the gearcase upside down by rotating the holding fixtureBe sure any excess grease is removed from the pinion needle bearingsDegrease taper of the pinionPosition the pinion in the gearcase29Degrease the driveshaft taper and install the driveshaftTurn the gearcase right side up