1999 "EE" 90, 115 FFI, 150, 175 V4, V6 FFI Outboards Service Manual, P/N 787024, Page 238Get this manual
41 DR2061
DR2062 13524
28Install two new seals back to back in the rear of the bearing housing, using OMC Seal Instller, PI 336311
1431 1441 1441 1451
29Apply OMC Gasket Sealing Compound to the metal casings of the seals before installingInstall the inner seal with lip facing toward the bearing housing, then the outer seal with lip facing away from the bearing housing30Apply OMC Triple-Guard grease to the seal lips after installi ng14214
31Apply OMC Needle Bearing Assembly Grease to the thrust bearing Position bearing around shoulder on the propeller shaft
32Apply OMC Needle Bearing Assembly Grease to the thrust washer Place washer in recess of bearing housing33Coat bearing surfaces of propeller shaft with gearcase oilSlide the propeller housing on the propeller shaftUse caution when assembling the propeller shaft in the bearing housingThrust bearing must remain around shoulder on the propeller shaft34Lightly oil the threads of the forward gear assemblyCarefully start the threads into the housing, and screw it in by hand as far as possibleTighten the gear assembly to torque of 100 ftIbs(136 Nm) using OMC Spanner Wrench, PI 43240035Attach the anode and tighten the screws to torque of 170-190 inIbs(19-21 Nm)