1999 "EE" 90, 115 FFI, 150, 175 V4, V6 FFI Outboards Service Manual, P/N 787024, Page 223Get this manual
11Check shimming by reassembling the driveshaft with shims and placing it back into the tool baseThe measurement between the gauge bar and the pinion should be 0.020 in(0,508 mm)12Remove the nut and pinion from the driveshaftAssembly
Before beginning assembly procedures, all gearcase com ponents must be thoroughly cleaned and in serviceable conditionRefer to Cleaning and Inspection1Assemble the following components of ONIC Pinion Bearing Remover and Installer, PI 391257, as shown:
OJ V4-20 inHex Head Screw
341437 Spacer PI 391260 Plate PI 326582 Rod PI 3265741nstallerRemover -20 1 inHex Head ScrewNot component of PI 391257
in0.0Flat Washer