1999 "EE" 90, 115 FFI, 150, 175 V4, V6 FFI Outboards Service Manual, P/N 787024, Page 220Get this manual
7Install two new seals back to back in the rear of the bearing housing V4use ONIC Seal Installer, PIN 326551 V6use ONIC Seal Installer, PI 336311
[][8Apply ONIC Gasket Sealing Compound to the metal casings of the seals before installingInstall the inner seal with lip facing toward the bearing housing, then the outer seal with lip facing away from the bearing housing Apply ONIC Trip leGuard grease to the seal lips after installing[] 9Lightly apply ONIC Triple-Guard grease toa new bearing housing O-ring(s)Install O-ring(s) in groove(s) in the housingDriveshaft Bearing Housing Service
The driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if the bearing is damaged[] 1Remove the driveshaft bearing housing seals using CIVIC Puller Bridge, PI 432127, and CIVIC Large Puller Jaws, PIN 432129Discard the seals2Remove the O-ring from the bearing housing and discard 3Clean the bearing housing in solvent to remove sealer from the seal bore and the O-ring groove[]]4Install new seals back to back in bearing housing using CIVIC Seal Installer, PI 330268Apply ONIC Gasket Sealing Compound to metal casings of the seals before installingInstall inner seal with flush lip facing toward bearing housing, then the outer seal with extended lip facing away from bearing housingApply ONIC Triple-Guard grease to seal lipsDR2062