1998 Johnson Evinrude "EC" Accessories Service Manual, P/N 520213, Page 181Get this manual
Assembly
1Lightly coat the piston and O-ring with OMC Power TrimlTilt and Power Steering Fluid or GM Dexron 1 fluid Install the piston into the cylinder2Lightly oil the end cap seals and slide the end cap onto the cylinder
rn to 30-35 ftIbs.SpannerNm)PI 912084, torque the end 3Using OMC Wrench, cap (40-47 rn 4Apply oilsecond hole inrod and install rod shouldhousing to the cylinder the valve assemblyThe the cylinder line up
with the hole in the valve housing Installation
1V6Attach power steering cylinder to the adapterTighten screws to 60-84 in Ibs(7-9 Nm)2V8Place the steering cylinder in the engine swivel bracket and slide the tilt tube into place
3V8Install the starboard locknutReplace the locknut if you do not feel definite resistance to tighteningTorque the locknuts to 50-54 ft.lbs(68-73 Nm) and then loosen one locknut Va to 14 turn