1998 Johnson Evinrude "EC" Accessories Service Manual, P/N 520213, Page 169Get this manual
126110Use No.3 internal retaining ring pliers to remove the bearing retaining ring1271 11 Remove the four screws, pump housing to reservoir12Remove he pump housing and gerotorDiscard the housing O-rings1Note To aid assembly, note which direction the gerotor alignment dots are facing12s1 13Gently tap on gerotor end of shaft with plastic mallet, and remove the shaft and bearing assembly1291 14Use No.4 external retaining ring pliers to remove the bearing retaining ring1Note Attempt to inspect all bearings in placeIf bearing is removed, it must be replaced1301 15Support the bearing cone and press upper bearing off pump shaft as necessary16To remove lower shaft bearing, use OMC Slide Hammer, PIN 432128, and OMC Small Puller, PIN 432131 Discard the bearing, if removed1321 17Use drag link socket to remove the pressure relief (front) and sump relief (rear) valve assemblies1Note Do not interchange pressure relief and sump relief valve assemblies or componentsIdentify the assemblies for inspection and assembly purposes E u