1998 Johnson Evinrude "EC" Accessories Service Manual, P/N 520213, Page 135Get this manual
v DRC6245 DRC6246
Trim Gauge Troubleshooting
1Turn key switch ONUsing voltmeter, check for voltage between the trim gauge "1" and "G" terminals If no voltage, check condition of instrument harness, key switch, and engine 20-amp fuse If voltage, go to Step 2
2Remove the whitetan lead from the trim gauge "S" terminalWith key switch ON, gauge should indicate full-trim DOWN positionNow connect jumper wire between the white tan lead and the trim gauge "G" terminalGauge should indicate full-trim UP position If your results are different, replace the trim gauge If your results agree, refer to Trim Sender Troubleshoot-