1998 Johnson Evinrude "EC" Accessories Service Manual, P/N 520213, Page 113Get this manual

1998 Johnson Evinrude "EC" Accessories Service Manual, P/N 520213, Page 113

Installation

1Place trimtilt unit into positionApply OMC Triple -Guard grease to the lower pin, and install the pin
2If loosened, tighten the tilt tube nut to torque of 50-54 ftIbs(68-73 Nm), then loosen one nut by Va to 1f4 turn3Install external snap rings on lower pin with sharp edge of ring facing out
4Extend tilt cylinder rod to match with holes in swivel bracket5Apply OMC Triple-Guard grease to upper pin, and install the pin

Back to 1998 Johnson Evinrude "EC" Accessories Service Manual, P/N 520213