1998 Johnson Evinrude "EC" 90, 115 SPL Service Manual, P/N 520209, Page 187Get this manual
[] 3Place the -ring Q) in groove in the impeller housing4Lightly coat the exterior of the impeller cup with OMC Gasket Sealing CompoundInstall the cup in the impeller housing rn 5upthe water tube grommet with the inside taper Install facing
6Install the impeller housing cover (6)7Apply OMC Adhesive sealant to flat side of the impeller housing grommet 1MlInstall the grommet, flat side down
rn 8Lightly the impeller into the liner withcounterclockwise coat the liner with oilWith rotation, install slot for impeller
cam facing out
rn 9Run ainstall beadspecial shaped -ring sealant in the seal thin of OMC Adhesive groove, and the seal Installation
rn impeller plate gasket CDInstallCompound andboth sidesplate 1Apply OMC Gasket Sealing to of new the gasket impeller
2Apply OMC Triple-Guard grease to new impeller a-ring Slide the a-ring down the driveshaft until it contacts the impeller plate3Apply OMC Needle Bearing Assembly Grease to flat area of the driveshaftInstall the drive camThe sharp edge of the cam is the leading edge during driveshaft rotation