1998 Johnson Evinrude "EC" 90, 115 SPL Service Manual, P/N 520209, Page 147Get this manual
1115 modelsIf filler blocks were removed, they must be installed flush with the cylinder blockNew filler blocks must be machined flush with cylinder block after they are installed Install filler blocks using brass screws and coat threads with OMC Ultra Lock Center and lower screws must use lock tabs Tighten all screws to torque of 30-54 inIbs(3,4-6,1 Nm) Bend up outside tab of lock tabs
rn 2Install the water deflectors in the cylinder block
3Lubricate the center main bearings and split sleeves with Evinrude or Johnson Outboard Lubricant and install them in their original positionsThe split sleeve ring grooves must face away from flywheel when installed
rn of crankshaftretainer plateflat side down, on lower 4Place bearing end rn 5To install OMC lower main bearing: Oil the end of the new crankshaftUse Crankshaft BearingSleeve Installer,