1998 Johnson Evinrude "EC" 90, 115 SPL Service Manual, P/N 520209, Page 75Get this manual
Inspection]1To test the solenoid windings, calibrate an ohmmeter on low ohms scale and connect between the purplewhite and black leads Meter should indicate 4-7 ohms 2To test solenoid valve and seat: Lightly pressurize inlet fitting with alcohol and syringe
rn With lever in run positionno fluid should enter inlet fittingrn With outletinfittingspositionfluid should come out of lever prime both
[] 3To inspect or replace internal components, remove the four solenoid cover screws[] 4When assembling solenoid, back up screws in their holes to engage original threads and tighten securelyInstallation 1Attach purplewhite leads and three hosesSecure large hose with tie strap2Install solenoid and bracketPosition ground lead under the inside bracket screw