1998 Johnson Evinrude "EC" 90, 100C, 105C, 115, 150, 150C, 175 60 deg. LV Service Manual, P/N 520210, Page 257Get this manual
COA3 130
, and shim(s)
Position the driveshaft thrust bearing 0, thrust washer (selected earlier) on the driveshaft
12011 Note Position bearing 0, washerand shim(s) exactly
in the order shown26Apply light coat of 0fv'IC Gasket Sealing Compound to the gearcase area that contacts mounting flange of the bearing housing Do not coat inside bearing housing bore surface of the gearcase
27Using avIC Driveshaft Seal Protector, PIN 318674, slide the driveshaft bearing housing onto the driveshaft28Push down on the shift rod to engage REVERSE gearTurn the gearcase upside down by rotating the holding fixtureBe sure any excess grease is removed from the pinion needle bearingsDegrease taper of the pinionPosition the pinion in the gearcase29Degrease the driveshaft taper and install the driveshaftTurn the gearcase right side up