1998 Johnson Evinrude "EC" 90, 100C, 105C, 115, 150, 150C, 175 60 deg. LV Service Manual, P/N 520210, Page 251Get this manual
0.125 in(3,2 mm) 29338 29330
Driveshaft Shimming Using Tool, PIN 393185 The driveshaft pinion is precisely meshed with the forward and reverse gears by using one or more shims between the driveshaft bearing housing and the thrust washerWhen installing new thrust bearing or washer, bearing housing, pinion, or driveshaft, it is necessary to properly shim the assembly to restore factory clearance Gauge bars are precision made and should be handled carefullyThe length of each bar is stamped near the part numberThis dimension is 0.020 in (0,508 mm) shorter than the actual shimmed length of the driveshaft
Degrease pinion and driveshaft tapers prior to assembly
[]] 1Assemble the driveshaft bearing housingthrust wash erthrust bearingand pinion onto the driveshaftUse OMC Driveshaft Seal Protector, PI 318674, whenever installing or removing the bearing housingLightly coat the threads of the pinion nut with outboard lubricant and torque to 70-80 ftIbs(95-108 Nm)2Select the correct gauge and collar: use OMC Gauge, PIN 328367, and OMC Collar, PIN 341440[] 3Slide the collar onto the driveshaft with large end in co ntact with the bearing housing