1998 Johnson Evinrude "EC" 90, 100C, 105C, 115, 150, 150C, 175 60 deg. LV Service Manual, P/N 520210, Page 250Get this manual
Driveshaft Bearing Housing Service
The driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if the bearing is damaged
1Remove the driveshaft bearing housing seal using OMC Puller Bridge, PI 432127, and CIVIC Large Puller Jaws, PIN 432129Discard the seal
2Remove the a-ring from the bearing housing and discard3Clean the bearing housing in solvent to remove sealer from the seal bore and the a-ring groove141 55
rn 4Install a341439ApplytheDPL Penetrating Lubricant toSeal new seal in bearing housing using OMC Installer, PI the
casing of the seal before installingInstall the the seal with the exposed lip facing away from the bearing housingPress the seal into the housing until the tool seatsApply CIVIC Triple-Guard grease to the seal lips after installing5Lightly apply OMC Triple-Guard grease to new a-ringInstall the a-ring in top groove of the bearing housing