1998 Johnson Evinrude "EC" 90, 100C, 105C, 115, 150, 150C, 175 60 deg. LV Service Manual, P/N 520210, Page 233Get this manual
1Assemble the driveshaft bearing housingthrust washerthrust bearingand pinion onto the driveshaftUse OMC Driveshaft Seal Protector, PI 318674, whenever installing or removing the bearing housingLightly coat the threads of the pinion nut with outboard lubricant and torque to 70-80 ftIbs(95-108 Nm)
2Select the correct gauge and collar: V4OMC Gauge, PIN 328367, PIN 341440 V6OMC Gauge, PIN 341440
PI 328367, and OMC Collar, and OMC Collar,
[] 3Slide the collar onto the driveshaft with large end in contact with the bearing housing
[]] tighten preload screw againstdriveshaft into the tool base rn 4Insert the assembled the driveshaft until groove and
on the spring-loaded plunger is flush with end of threadsTighten locking ring on preload screw