1998 Johnson Evinrude "EC" 90, 100C, 105C, 115, 150, 150C, 175 60 deg. LV Service Manual, P/N 520210, Page 221Get this manual
[] 3Place the a-ring Q) in groove in the impeller housing 4Lightly coat the exterior of the impeller cup with OVIC Gasket Sealing CompoundInstall the cup in the impeller housing[] 5Install the water tube grommet facing up with the inside taper
6Install the impeller housing cover (0
7Apply OMC Adhesive sealant to flat side of the impeller housing grommet Install the grommet, flat side down
8Lightly coat the liner with oilWith counterclockwise rotation, install the impeller into the liner with slot for impeller ca faci ng out9Run thin bead of OVIC Adhesive sealant in the seal groove, and install the special shaped a-ring seal
Installation
rn impeller plate gasket CDInstallCompound andboth sidesplate 1Apply OMC Gasket Sealing to of new the gasket impellerrnSlide the OMC Triple-Guard grease to until impeller a-ring 2Apply new a-ring down the driveshaft it contacts the