1998 Johnson Evinrude "EC" 9.9 thru 30 HP 2-Cylinder Outboards Service Manual, Page 297Get this manual
[U] DR5446
4Assemble armature to frame and magnet assembly, aligning marks on drive end cap and frame5Install insulated brush and terminal set in commutator end cap with long lead in slotPosition the insulators and nut as shown in figure
INote Reversing
backwards
these brushes will cause starter motor to run
6Install brush holder, brush springs, and ground brushesScrews secure ground brush leads and holderInsert insulated brushes in holder
7Assemble end cap to frame and field, aligning notch and ribA suitable tool for holding brushes in place can be made from putty knife 8Put drop of oil on thru-bolts before assembling starter motorInstall thru-boltsTorque thru-bolts to 95-100 inIbs(11-12 Nm)Seal with OMC Black Neoprene Dip