1998 Johnson Evinrude "EC" 9.9 thru 30 HP 2-Cylinder Outboards Service Manual, Page 292Get this manual
Solenoid Tests
INote All engine wiring must be disconnected from the solenoid
before proceeding with this test[] 1Calibrate ohmmeter on appropriate scaleConnect one lead to terminal and the other lead to terminal The ohmmeter should show high reading If the ohmmeter reading is low reading, replace the solenoid[] 2Attach positive battery jumper to terminal and negative battery jumper to terminal The solenoid should close with an audible click The ohmmeter should show low reading If the ohmmeter reading is high reading, replace the solenoid
ave Black Neoprene Dip
3After installing the solenoid, coat all wires and terminals with
No Load Current Draw, Electric Starter
INote Securely fasten
starter in vise or other suitable fixture before proceeding with this check1Locate battery rated at 350 cold cranking amps or higher that is in good condition and fully charged, to perform this test