1998 Johnson Evinrude "EC" 9.9 thru 30 HP 2-Cylinder Outboards Service Manual, Page 275Get this manual
8Bend the inside loop of the rewind spring in toward the center ofthe starter housingEngage the pin of the pulley with the inner loop of the rewind spring and install the pulley in the starter housing
9Lightly apply CIVIC Triple-Guard grease or Lubriplate 777to the spindle bushing and pawl pins on the pulleyInstall the bushing and the shim into the starter pulleyNext install the friction platelinks, and pawlsSecure the pawls with the retaining clips10Lightly apply CIVIC Triple-Guard grease or Lubriplate 777 to the spindleInstall the spindlefriction ringand two spring washers
INote The flat section of the friction
be aligned
ring and spindle
11Clean threads of the spindle retaining screw and nut to remove adhesiveInstall the spindle retaining screw and washer into the starter housingTighten screw to torque of 120-145 in Ibs(14-16 Nm)Spray threads of spindle retaining screw that protrude through the starter housing with CIVIC Locquic PrimerApply CIVIC Nut Lock to the threads of the nutHold the spindle screw and torque the nut to 120-145 inIbs(14-16 Nm)