1998 Johnson Evinrude "EC" 9.9 thru 30 HP 2-Cylinder Outboards Service Manual, Page 257Get this manual
26Apply OMC Marine Wheel Bearing Grease to lip of seals in the seal carrier assemblyPress spacer and seal carrier assembly into bearing housing using finger pressure 1221 1
27Using retaining ring pliers, install snap ring with beveled side of retaining ring facing outwardMake sure the retaining ring is seated in its grooveWear safety glasses and proceed with care to avoid unsnapping the ring from the pliers
28After assembly is complete, rotate driveshaft in bearing housingThe assembly should turn freely29Coat three new O-rings with OMC Adhesive sealant and install in grooves in the bearing housing
30Place bearing housing assembly into jet housing and secure using two slotted head screws
Water Pump Servicing
1Apply OMC Gasket Sealing Compound to metal casing of new impeller housing sealInstall the seal flush with the housing, and lip of it facing upApply OMC Triple-Guard grease to lip of seal