1998 Johnson Evinrude "EC" 9.9 thru 30 HP 2-Cylinder Outboards Service Manual, Page 243Get this manual
Assembly
INote Make no dry assemblies1241
Lubricate bearings, shafts, and gears with OM: Ultra-HPF gearcase lube
1Oil and install new bearing in aft end of the bearing housing using OM: Bearing Installer, PI 335820Press against the lettered side of the bearing to prevent damage to the bearing when installingPress the bearing into the housing until the tool is seated on the housing
2Oil and install new bearing in the forward end of the bearing housing using OM: Bearing Installer, PI 321428Press against the lettered side of the bearing until the tool is seated on the bearing housing3Install new seals backto back in aft end ofthe bearing housing using OM: Seal Installer, PI 335821Apply OM: Gasket Sealing Compound to the metal casing of the seals before installingInstall the inner seal with lip facing into the bearing housing and install the outer seal with lip facing away from the bearing housingApply OM: Triple-Guard grease to the seal lips after installing