1998 Johnson Evinrude "EC" 9.9 thru 30 HP 2-Cylinder Outboards Service Manual, Page 241Get this manual
15Use avIC Bearing Puller, PI 432130, attached to OMC Slide Hammer, PIN 432128, to remove the forward bearing cup
Secure the puller jaws into grooves behind the cup with jaws facing port and starboardUse OMC Wrench, PIN 334359to hold the puller while tightening the jaws
16Use avIC Puller Bridge, PI 432127, and OMC Small Puller, PIN 432131, to remove the driveshaft seals from the gearcase
INotellnspect bearings in placeIf bearing is removed for any reason, it must be replaced
17Remove the upper driveshaft bearing and bearing sleeve from the gearcase using the same two toolsDiscard the bearing
18To remove the pinion bearings, assemble the following components from avIC Universal Pinion Bearing Remover and Installer, PI 391257:
PIN 326582 Rod PIN 326583 Pilot Plate PIN 326577 Remover and Installer 114-20 x'2 inHex Head Screw 114-20 1'4 inHex Head Screw CD in0.0Flat Washer