1998 Johnson Evinrude "EC" 9.9 thru 30 HP 2-Cylinder Outboards Service Manual, Page 233Get this manual
7Using OMC Bearing Installer, PI 319931, and an arbor press, install the driveshaft bearing into the bearing sleeve with the lettered side against the tool
[] 8Oil the bearing sleeve and install with the bearing into the gearcase using OMC Bearing Installer, PI 319931Keep the lettered side of the bearing against the tool
[]] rn 9Using OMC Sealback as follows:326554, install two Installer, PI new driveshaft seals back to
Apply OMC Gasket Sealing Compound to the metal casing of the seals before installing Install the inner seal Q) with lip of the seal facing toward the gearcaseInstall the outer seal with lip of the seal facing away from the gearcase Apply OMC Triple-Guard grease to the seal lips after installing10Coat the shift rod a-ring with OMC Triple-Guard grease and install in shift rod bushing
11 Place new washer and bushing Ml on OMC Shift Rod Bushing Installer, PIN 304515Apply OMC Gasket Sealing Compound to the outside diameter of the shift rod bushingUsing mallet, drive the bushing into the gearcase