1998 Johnson Evinrude "EC" 9.9 thru 30 HP 2-Cylinder Outboards Service Manual, Page 205Get this manual
Installation
1Insert the stop button leads and the throttle cable through the lower engine cover grommet2Apply OMC Triple-Guard grease to the two steering handle bushingsPlace the bushings into the steering bracketAttach the steering handle to the steering bracket[] 3Tighten the nut so the steering handle can be pivoted and maintain any position4Slide the protective sleeve over the stop button leads[] 5Secure stop button ground lead to bottom ignition coil mounting screwTighten screw to torque of 48-96 inIbs(5,4-10,8 Nm)
m 6.into theOMC Insert Tool, PIN 322697,Amphenol stop button Using install the lead plugConnect the 5-pin connectorSecure connector with wire retainer