1998 Johnson Evinrude "EC" 9.9 thru 30 HP 2-Cylinder Outboards Service Manual, Page 199Get this manual
Installation 1Insert the stop button wires and throttle cable through the lower motor cover grommetUse isopropyl alcohol on the sleeve to ease assembly[] 2Apply OMC Triple-Guard grease to the steering handle sleeve, and place the sleeve into the steering bracketReplace sleeve if necessary3Attach the steering handle to the bracketTighten the nut just tight enough so the steering handle will maintain any position
Replace the steering handle locknut if it has lost its locking action
rn on the lower screw, button ground lead behind the ignition 4Secure the stop coil with starwasher next to block[] 5Use OMC Pin Insert Tool, PI 322697, to install the stop button black wire into the 5-pin Amphenol plug