1998 Johnson Evinrude "EC" 9.9 thru 30 HP 2-Cylinder Outboards Service Manual, Page 115Get this manual
Amphenol Connector Servicing
INote The Ampheno pin and socketterminals are not the same
size as Deutsch pin and socket terminalsYou cannot interchange themTerminal Removal
1To remove terminal from the plug or receptacle, lubricate both ends of the cavity with isopropyl alcohol
Pick the proper tool for the service being performed:
OMC Pin Remover, PI 322698
OMC Socket Remover, PI 322699 OMC Crimping Pliers, PIN 322696 OMC Insert Tool, PIN 322697
2Place the plug or receptacle against the edge of flat surface with clearance behind connector for terminal to be pushed outPush terminal from connector with tool or 3Pin and socket terminals may be replaced if damaged Strip 1f4 in(6 mm) insulation from wire and crimp new terminal onto wire at point with crimping pliers42226