1998 Johnson Evinrude EC 50 thru 70 HP 3-Cylinder Service Manual, Page 250Get this manual
DR5446 371 54
4Assemble armature to frame and magnet assembly, aligning marks on drive cap end and frame
5Install insulated brush and terminal set in commutator end cap with long lead in slotPosition the insulators and nut as shown in figurebackwards
I Note Reversing these brushes will cause starter motor to run
6Install brush holder, brush springs, and ground brushesScrews secure ground brush leads and holderInsert insulated brushes in holder
7Assemble end cap to frame and field, aligning notch and ribA suitable tool for holding brushes in place can be made from putty knife8Put drop of oil on thru-bolts before assembling starter motorInstall thru-boltsTorque thru-bolts to 95-100 inIbs(11 -12 Nm)Seal with ONIC Black Neoprene Dip9Install pinion base and pinion on armature shaft38285